Pages
Categories
Archives
- February 2021
- January 2021
- October 2020
- July 2020
- March 2020
- February 2020
- January 2020
- October 2019
- August 2019
- May 2019
- November 2018
- July 2018
- June 2018
- May 2018
- March 2018
- February 2018
- January 2018
- July 2017
- June 2017
- May 2017
- April 2017
- March 2017
- January 2017
- November 2016
- June 2016
- March 2016
- December 2015
- June 2015
- April 2015
- June 2014
- December 2013
- November 2013
- July 2013
- January 2013
- October 2012
- September 2012
Twitter Updates
- RT @doismellburning: Amplifier and filter set up, currently using a spare Yagi from @G8GKA but no Norbi packets received yet - anyone got a… 1 month ago
- @doismellburning @blu3id @MattStibbs If both ends of the cable are disconnected, you could check for continuity / r… twitter.com/i/web/status/1… 1 month ago
- @g7soz I didn't know you can buy new end-plates. Thanks for sharing. 3 months ago
- @lex_ph2lb It’s based on the “Simple RF Power Reference” design by W1GHZ and uses a Qantek, 50 MHz HCMOS oscillator. 3 months ago
- @JohaPrime The design is by PA0RWE and I’m using the MCP1501-20 device. 3 months ago
Meta
Monthly Archives: February 2020
An Arduino Based Four Event Sequencer
When putting together a system using RF switching relays, Low Noise Amplifiers (LNA) and RF power it’s important that things are switched at the right time and in the correct sequence. This ensures that the relays do not actually switch … Continue reading
Posted in Arduino, Blog, GHz_Bands
Leave a comment
